Nibiru VR Development Nibiru Studio calibrate

calibrate Post time 2017-9-29 18:58 | Show all posts [Copy URL]
1 1028
i have a "vr sky cx-v3" VR Headset.

Now, if I start the device, it´s forced me to calibrate it.
I dont know how?!

The start picture show "put the glass on the table ; start calibrate" if it´s calibrate, there will emite first a yellow light, then a green light for finish.
One time, it calibrate, but i dont know how and why.

How do I start calibrate?
Please can you tell me this?
Is an upgrade an alternativ workflow for this problem?

Kind regards

Use magic Report

Post time 2017-9-29 18:58 | Show all posts
Hi, The boot calibration is set by the program of our system,the program can ensure the correct display of the position of the screen, but also to stabilize the gyroscope, to prevent the current picture drift deflection.

The program will only appear for the first time on the boot, and will not run again later。
You have to log in before you can reply Login | Register

Points Rules

!fastreply! Top !return_list!